Biqu H2 fan base for CoreXY printers
Description
Hi all, This is my first upload of a thing. I've detached the actual fans from the Biqu H2 and connected it via a tube. Note that is still a W.I.P. so there may be some issues. Features: - The front fan is upgraded to hold a 40 mm fan instead of the 35 mm - Air duct to reduce weight and overall footprint - Two 5015 radial fan fittings or one 120mm regular fan. I've printed the main part with my resin printer, but the mounting for the fans can be printed easily enough with an FDA printer. Additional requirements: - Approx. 150 cm flexible tubing, with a 2 cm diameter (I used a washingmachine tube) - A few M3 fittings for the fan base to secure your fans - T-nuts to secure the fan base to your case - Fans if required. Notes: Be sure to rotate the heatsink about 90 degrees so the shroud doesn't touch it. The shroud is fixed to the and cannot be adjusted in height, but should have enough clearance. The high-inlet version has the inlet at approx the same height as a cable chain would be.
Statistics
Likes
0
Downloads
0