Sink Buddy
Description
I needed a holder for our Scrub Daddy in our sink. None of the ones we saw available met my wife's preferences for aesthetics, so I designed one! This holder is designed to fit the standard "Scrub Daddy" sponge, but should also fit any other similarly sized products (Scrub Mommy, Eco Collection, etc. The standard intended attachment method is via suction cups (I used the ones found on Amazon here: https://a.co/d/60IFpn5, but I'm sure other similarly sized suction cups would work as well). You could also use a double sided adhesive/3M strip for a more "permanent" attachment. To install the suction cup, slide the "nub" of the suction cup into the lower slot on the Sink Buddy at a slight angle. Once the nub is fully through the lower hole in the slot, pull it upward into the higher portion of the slot. It helps to rotate the suction cup or the Sink Buddy back and forth while pulling upwards to help get it to pop into the upper slot. Most suction cup "nubs" are designed to be slightly recessed in the upper slot, but larger ones may protrude a bit. This should not be an issue due to the size and location of the eye holders and the lower ledge. This design is the result of a couple prototype iterations, but please feel free to provide any feedback you have on potential areas for improvement if you print one and try it out!
Statistics
Likes
0
Downloads
0