ClipTech compatible latch for Craftsman tape measure
Description
Unfortunately I haven't had a successful print with this particular model due to all sorts of reasons, but all the basics should work! Due to the geometry of the actual latch, I tried printing flat (tape measure side down) so the spring doesn't just break the first time you try to use it, and to save time. Of course, supports are recommended ### Installation In my case, I have a 25 foot Craftsman, and the original clip is held on by a single screw. All you need to do is remove that single screw and this print should fit snugly. Pictures 2 and 3 show the general process, but don't do what I did and rip the print in half when removing supports :) **This is my only tape measure, so I can't ensure this is compatible with any other tape measure**
Statistics
Likes
0
Downloads
0