Wiha Torx Driver Stand (for 3 or 6 drivers)
Description
I work on knives a lot, and am always using the same 3 Wiha Torx drivers, so I built a stand to keep them neat on my workbench. If you use all 6 in the set, there's an STL file for you, too. Print whichever top you want (they print *upside down*) and print two legs. There are stops on the bottom face of the top that keep the legs from sliding in too far. You can hot glue the legs in place if you like, but it's not necessary from what I've seen so far. Bear in mind that this design works with the tolerances on my personal printer. You might want to print a single leg and the top first, just to make sure that they fit well.
Statistics
Likes
0
Downloads
0