Stronger Headphone Clip Stand
Description
The original headphone holder seemed very weak and required unnecessary supports to print. So, I remade the male end from the ground up with the following changes: - Increased width of the interlocking pin to no longer require any supports when printing on its side - Increased pin thickness for strength - Pin is now in line with the bottom part of the clip to hopefully improve strength I also tweaked the female end that the headphones actually rest on: - Adjusted the slot to fit the larger male end - Widened the entire curve to accommodate for larger headphones - Made the top end chamfer shallower so that the overhang is easier to print Just like the original, I provided SLDPRT files so that you can change the dimensions of the male half to fit your desk. I made this print custom for an irregular width. My tolerances were a little loose, so I'll put some hot glue in there to connect them. I reduced the tolerances before uploading the files so hopefully it won't be as big of a problem for you, although I still do recommend glue. The female end took 2 hours to print when oriented with the flat part (that connects to the male end) facing down on the print bed. The male end took 3 hours when placed flat on the bed (from a top down view it looks like a number four or a lowercase h).
Statistics
Likes
0
Downloads
0