Drag-Ornament xmas ornament
Description
inspired by the cat ball ornament from my friend (which you can find a remix of also by me), i wanted to make a dragon version. this is a hollow ornament, so you can put a little object inside (a cube, a sphere, a marble, a little bell) and it tinkles when you shake it! printed on an Artillery Sidewinder X2 with some classic pla, choose whatever resolution you deside but scaled to ~2 inches it required me almost 2 hours of printing at 60mms, 1:30 hours at 120mms with 0.28 layer height. supports required for snout and curve at base (this model has no flat base so you can print full supported or sink 1-2 mms to get a flat surface) but i suggest to use skirt (not rafts) to prevent the model detach and run everywhere on the printing bed.... just tell me if you liked it :3
Statistics
Likes
0
Downloads
0