Subaru Legacy GT 05 - 07 MAF mount - Cone Filter
Description
Part requires 2x bolt studs to thread the MAF sensor to the pipe securely Part has the same diameter as the original intake as well as the same design to allow air to flow through the MAF correctly. Relearn procedure may be required after applying the cone filter and pipe, tune should not be necessary. Busy designing the box but creating an a box out of a sheet of 2mm thick Aluminum may be a good alternative to keep the air cold and block on the engine bay temps. TPU 95A can also be used to make the part but then you will require an Aluminum pipe and silicone (Or 3D printed pipe to mount it onto the intake)
Statistics
Likes
0
Downloads
1