Magnetic Poop Chute Box P1P / P1S
Description
Simple magnetic poopchute box for Bambulab P1P/P1S printers. There is a big box and small box. I had a problem with the smaller box, it would slide down the side of the printer. The magnets in both the bracket and the box help keep the box secured nicely. The longer box is designed to come down flush with the edge of the printer case. I designed it not to go down flush with the feet of the printer, because I put mine on my carpeted floor. The carpet pretty much absorbs the feet, so the box sits flush with the carpet. -NOTES- Box v1: this version blocks the area where the filament spool hangs, it works great if you have an AMS or other external filament spool holder Box v2: this version has a cutout to allow the filament spool to hang next to the poopchute box Bracket v1: this version is designed so that the printer should automatically pause at Layer 27, allowing you to slot the magnets into place, then continue printing Bracket v2: this version has open magnet holes, allowing you to slot the magnets in after you print it -NEEDED- 36 - 1/8 * 1/8 in. (3.175 * 3.175 mm.) cylindrical magnets [18 for box and 18 for bracket] I usually bulk buy my magnets from TotalElement, you can get 200, N48 magnets for ~$20. https://totalelement.com/collections/disc-magnets/products/1-8-x-1-8-inch-neodymium-rare-earth-cylinder-magnets-n48-200-pack (not sponsored)
Statistics
Likes
0
Downloads
0