Tea Mesh Holder
Description
When I am making delicate tees, I want to remove the tea from the water so that the tea does not become bitter. But then I need a place to put the tea! A little plate or paper towel to put the tea will do, but that annoyed me. Too many hands! I just want to grab my teapot and go. If only there was a thing that could hold the tea mesh and attach to the teapot... Now there is! With this you can put your tea down on the table or put it down directly on the teapot. Will this fit Your Teapot???: This is a very common teapot design that is mass produced, and often unbranded. This will work for any similar teapot. If you recognize the teapot shape, there is a 99% chance that your teapot is the exact same size and dimensions and this will fit right away. The important thing is that the hole in the bottom of the mesh holder fits on the knob of the teapot cap. This can be easily adjusted by changing the scale of the STL accordingly. Teapot Temperature Note: I really only drink oolong, green and white teas which are steeped at low temps, so I have never had a problem with the print deforming or melting during use. If you drink teas that steep at higher temps, you may want to use a more heat resistant filament or wait until the pot cools off a bit before using this print on the teapot itself.
Statistics
Likes
0
Downloads
1