Curve Gauge for casting design
Description
In Trying To Model Cast Parts, The Inside Radius Of Curvature Is Often Hard To Measure With Just Calipers. The Stl Files Are Stepped Half-Rods That Start With 10Mm Diameter And 20Mm Diameter. Select The Step That Best Fits The Curve In Your Casting, Then Read Or Measure The Diameter/Radius For Your Modeling Software. These Can Also Be Used For Karge Hole Measurement In Locations That A Ruler Or Calipers Are Difficult. Scad Source Files Are Included. Adjust Parameters For Minimum Diameter And Number Of Steps. Step Size Is 2 Mm Diameter Or 1 Mm Radius. Diameter Is Marked On Alternate Steps In The Flat Surface, Also.
Statistics
Likes
9
Downloads
0