Kobra 2 neo z-axis filament tube holder
Description
### Anycubic Kobra neo/2neo filament tube holder I designed this to fit with a upper spool setup and to prevent the filament from bending hard on the left side (with the original tube location). It might slightly affect the maximum printable height since the tube will bend at some point but it shouldn't be too bad. Mounts on the right z-axis arm, same spot as a z-axis stabilizer. ### Printing time Printing time takes **17 min** on the Kobra 2 neo with speed at a 100% ### Mounting Two **M2x19mm** screws are needed
Statistics
Likes
0
Downloads
0