Dual Fan Donut Shroud for Folger Tech 2020 Prusa i3
Description
1St Off, This Is A Work In Progress, And I Have Not Printed The Full Thing Yet, Just Parts Of It. Once I Do, I'Ll Upload The Pictures. Update 8/6/2015: My Measurements For The Mk7 Extruder Assembly Was Off A Bit. Fixed That, And In Turn Had To Fix The The Other 2 Parts To Fit. Update: I'Ve Uploaded The 2 Clamp Version. It Will Clamp On The Motor And The Hot End Fan. Still Have Not Printed Them To Check Fit. This Should Make Bridging With Pla A Lot More Feasible. That'S The Idea Anyways. Print It In Abs With No Supports @ .2 Or .3 Layer Height. I Have Printed The Donut Part Successfully. I Have To Test The Fan Funnels Next. I Used Repetier Host To Print. Slic3R Prints Were Not As Good As Cura. It'S Designed To Be Used With 40Mm Fans. I'M Currently Working On Changing The Mounting To Be A Little Easier To Put On And Take Off. It Will Basically Have 2 "Clamps", On In The Back, As In This Design, And One In The Front. I Will Upload It As Soon As I'M Done With It. P.S. With .3 Layer Height, Cura Estimated About 2 Hours, But Will Probably Take About 2:30 Or 2:45. At .2 Layer Height, Cura Estimated 3 Hours, So It Will Take About 4.
Statistics
Likes
49
Downloads
0