AtomRC Penguin Nose
Description
I'm new to scanning. This is my first real project with a scanned image. It came out "ok" but then needed some work. I'm new to the design side too, so I was pushing the limits on TinkerCAD. My original nose has been well used, so scanning it meant there was some roughness on the bottom. I've cleaned it up a bit. Printed in TPU as it needs to squeeze a bit into the mounting holes. Magnets are 10mm diameter, and 4mm thick. I used hot glue in the hole for the magnet, then really firmly pressed in to get the glue all around.
Statistics
Likes
0
Downloads
0