MTW Midcap GEN-1 Upgrade Follower
Description
The original MTW midcaps tend to hold onto one bb that they will not release, making it look like you still have bbs in your magazine. This extended follower makes sure that your magazine will eject the last bb and still actuate the stop on empty micro switch. I have printed a few of these and done some minimal testing. So far and they seem to work fine. Depending on your printer you may have to sand the sides of the peg that actuates the stop on empty bar to get the follower to travel smoothly around the curves in the magazine.
Statistics
Likes
0
Downloads
1