Belt Holder for the printing bed (Y axis) of a PRUSA I3

Description

This Is A Belt Holder For The Y Axis Of The Sunhokey Prusa I3. I Changed The Original Printing Bed (Which Was Too Soft Because Made In Acrylic On The Sunhokey'S Kit, And Leading To Permanent Needs Of Bed Leveling) By A Mk2 Aircraft Aluminium Bed (Very Rigid). With The New Printing Bed, There Is The Need To Drill The Holes In Proper Place For The Linear Ball Bearings (Take The Position Of Them On The Old Acrylic Printing Bed), And Also There Is A Need For A New Belt Holder. This Auto Locking System Of The Belt Is Derived From The Belt Clip I Recently Published. It Do Not Take Any Tool To Install The Belt, Because The Belt Is Natively Maintained In A "Self-Locking" Position By This Belt Holder. Just Insert The Belt Inside The Groove And It'S Done ! The Sketchup File Is Attached In Case Of Need Of Adaptation. This Belt Holder Have Been Created As A Quite Universal One For This Kind Of Printers, So The Base Is Larger Than Needed In Case Other Holes Reveal To Be Necessary For Some Other Printer. Hence, It Should Fit With Any Other Printing Beds Of The Same Category Of Printers. For A Better Quality Of The Printing Of This Device, It Is In 2 Parts Which Just Has To Be Assembled By A M3 Bolt And Nut.

Statistics

Category

Tags