JONSBO C6 Panel Clip V2
Description
This is a V2 remix of the other clip I made. This clip has a ball joint clip on it that snaps over the panel mounting points. Keeps it more secure since the panel cant sit inside of the case like it could. I did print mine in PETG and I don't think thats the best filament to use. Its better for heat resistance but PLA snaps in place better. I think PLA+ will be fine since its at the front of the case but you might try to use ASA or ABS. Those do shrink so you might want to adjust for that. I also had to print with supports in a vertical position. I used tree supports and if your settings are good you might not even need supports since its only 6mm wide. I printed the PETG without the part cooling fan on it and the supports were small. I also had one side snap as shown in the picture but that was because my PETG had moisture. After drying and reprinting, it is stronger. I might make the part a little thicker their if I need to but it doesnt do much, the center part is what has any pressure on it
Statistics
Likes
0
Downloads
0