Swann Doorbell Backplate
Description
A reinforced doorbell back plate remixed from https://www.thingiverse.com/thing:3250400 After moving into a new house - The original back plate was already busted - with the weather seal long gone. I printed out the original - but the housing was still loose on the plate, so added some corners to hold it a little more securely - as well as adding a bit of re-inforcing to the tabs on each end. Left out holes for the screws as I chose to mount the plate via weather proof double sided adhesive tape - but can drill holes without an issue - Although if you choose to use screws, be careful you don't warp the plate by tightening the screw too much as it will affect the fit of the housing (I did this twice before I figured out what was wrong) Its kinda ugly, but the doorbell isn't going anywhere now.
Statistics
Likes
0
Downloads
0