Katamari Extruder Visualizer / Spinner: Ender 3 S1
Description
Once I found out about extruder visualizers, I knew I needed to make this. Now you too can watch a little katamari roll while your Ender 3 prints! The adaptor was borrowed from PartyBUS's extruder visualizer because I was too lazy to take my own measurements. It fits onto the extruder with friction, not a magnet, so you may need to print it more than once to get the tolerance just right. Some people have said to scale it down to 98.5%, but mine fit very tightly when scaled to 99.5%. Even at 100%, there should be no clearance issues with the cooling fan. This was designed with only the S1 in mind, so you may have to do various tweaking to get it to fit on your printer. Also, when I imported it into Cura, it warned me about certain faces not being present, if you see that too, don't worry about it and just slice it as you normally would, everything turns out fine.
Statistics
Likes
0
Downloads
1