Elegoo Neptune 3 Pro X-Axis Cover (Left)
Description
This is the (Left) X-Axis Cover remixed from SebastianRubner's tension stopper design. You will need to unplug the connector to install this. I would recommend doing this while the printer is off. Tip: (Unplug the connector, push the connector into the hole and let the piece hang from the wire while you plug the connector back in and then push the cover into place.) This is a pressure fit design so it should fit nice and snug but don't worry if you do break it this only takes about 30 minutes or so to make.
Statistics
Likes
0
Downloads
0