NetApp DS4243 DS4246 - HPE 3par M6720 disk tray
Description
This is a remake of <a href="https://www.thingiverse.com/crsleeth">crsleeth</a>'s <a href="https://www.thingiverse.com/thing:3151516">thin disk tray</a>. I used his design as a reference, replicating the handle, the two side indents, the height, and the thickness measurements. However, I noticed that his version didn't fit over a 3.5" drive properly, and the screw holes were misaligned. To address this, I increased the width for a better fit and adjusted the screw hole spacing from 100.6mm to 101.6mm. Additionally, I found that the material-saving holes in the original design compromised the print quality with the PETG I use. Since the printing time is unaffected by the presence of these holes, I opted for a solid design without them for a cleaner appearance. I am using these in a HPE 3par m6720.
Statistics
Likes
0
Downloads
0