Fat-Thumb-Mini-Vise
Description
Fat-Thumb-Mini-Vise Measurements in inches: 2.1250 Long 1.5 Wide 15/16" Tall. Small Vise!! But it's really handy!! This is a extra-nise little mini finger-vise. Works great. Opens up to 1-inch. For those tiny things needing a bit of filing or dremiling or painting, gluing etc... Uses 10-24 standard flat-head Phillips screws with a washer. I had a few stainless steel screws laying around and used them. Has a small 3/16 inch bottom aluminum round rod slide-guild on it. You may can do without it for lots of your work. Use what you have. Also has recess for 10-24 nuts, but I did not have any and found out they were not needed at least while it is new. Yet as it wears a bit they may be needed. Use a #25 drill bit and ream the ram part and it will cut is's own threads. Ream the front screw holes with a #11 bit for screws to slide in and out without threads. Use a 3/16th drill bit to ream the slide-guild rod holes in both parts. Sand-paper where needed, you need close sliding and fits. I am really proud of mine........hope yours works out as well, Thanks, Rick.
Statistics
Likes
0
Downloads
0