Clamp Roller: Roll Support for Spools Ender3 V2 remix for bearings
Description
Not all filaments allow for a smooth roll so i decided to use real bearings. This is a remix from [Ilikon](https://www.thingiverse.com/thing:4804090) I made 3 designs: * No holes * Pre-holes * SexyDesign <u>NO HOLES</u> In case you have a weird size bearing you can drill the holes yourself. Make sure that the area where the holes will be drilled is at 100% infill; the rest can be at 20% infill. (You set regions in your slicer) <u>PRE-HOLES</u> Works great for 4mm inner diameter bearings: 604, 624, etc <u>SEXYDESIGN</u> Not tested but hopefully it works for 3mm bearings: 603, 623, etc. Since these bearing do not have enough outer diameter i have made some round curves to allow contact with bearing. give it a try and let me now if sexy design works. It has no holes so make sure that are has 100% infill to drill holes. EXTRA: * Support must be enabled except in hinge area (see image) * Using long screws on the clamp closer to the vertical-stand allows the clamp to sit better and prevents clamp from sliding. * blender file is attached as well
Statistics
Likes
0
Downloads
0