Autococker Freak barrel Inception Designs Fronts
Description
There are two types of barrel pieces located here and they are incompatible with each other. See individual file descriptions for details, but anything labeled ID is for an Inception Designs back only. This is a work in progress, I have only printed the barrel and short can. AC hush barrel - Freak inserts fit. I printed with supports and it was a huge pain to get them out, but doable. I ran a pencil with steel wool on a drill through the barrel to clean it up after printing which worked well. The hush cans thread on to the end of this Hush can long - goes on the printed barrel, print this with the long endcap. I have not printed this yet to test it. Hush can short - goes on the printed barrel, print this with the short endcap. I have printed this and it fits very well. Hush can long single piece - I have no idea how you will print this. I played with it in the slicer and I think it needs more work. It was intended as a single piece rain cover in the long configuration. ID noot front - goes on the front of your Inception Designs barrel back. IT IS LOUD. ID ported front - goes on the front of your Inception Designs barrel back. I haven't tested it yet. ID can - theoretically goes on the front of the Inception Designs back, but I have yet to print it. I honestly wouldn't print this yet as I'll be doing a lot of work on it. Go for it if you're brave.
Statistics
Likes
0
Downloads
0