Cash Organizer (USD)
Description
I looked at a few other cash organizers on thingiverse, but I wanted more of a staggered "stadium seating" style organizer, where the top of each bill is clearly visible. * Each of the slots is raked back a little bit. * Each slot as drawn is 1.25" deep, and the bottom of the slot is at a 90* angle to the back (and front) of the slot. * The walls/dividers are 1/4". * As drawn the whole thing is a little over 11" long, which may be too long for your printer. I scaled the Y axis down to 70% and it printed perfectly on a Sovol SV06. * Make sure you ONLY scale the the long axis (Y in my case), because if you scale the width, your cash won't fit! Print settings: * I printed mine using PETG, mostly because I had a roll I wanted to use up. * I scaled the Y axis to 70% to fit on my 220x220 bed. * I used 10% infill, using the "cubic subdivision" pattern to save filament. * This used about 280gr of filament. * I experimented with a few ways to save filament, and couldn't save any additional filament over the built in cubic subdivision infill pattern.
Statistics
Likes
0
Downloads
0