Rubber Band Powered Car
Description
This Is One Of The Three Series Of Rubber Band Powered That I Have Made. There Are Two Photo Attachment Of The Previous Version Of The Model. Until This Model Is Printed, The Obstacles That I Face Is That I Get All Four Wheels Are Angled Hole, Or Holes Not Perpendicular And Make Wheel Shake When Turning. And The Upper Part Of The Body Is Too High Causes A Nut And Bolt Holes Slightly Shifted Due To Swaying During Printing. This Material You Need: 1. M3 Nut And Bolt Length 10Mm 2. 1 Piece Of Rubber Band 3. Paperclips Cut 30Mm: 2 Pieces 4. Loosespokes Bike (Diameter: 1.94Mm) Cut 80Mm: 2 Pieces 5. Rapid Cure Adhesive (Cyanoacrylate Adhesive) 6. Lubricant Spray, Which I Used To Use In My Bicycle Chain Https://Www.Youtube.Com/Watch?V=2Bvbfbmpapg
Statistics
Likes
188
Downloads
0