Higher Flow LARGE Sponge Filter
Description
The sponge I use on this I got off Amazon they are about 6" tall and just over 4" diameter. Print everything at 99% infill You should not need any supports except for the flow bender, BUT i sliced that into 2 pieces, printed without supports and glued together. The outer cavity of the base i filled with sand, then glued the lid on. After that i glued the sponge tube in place. Then glued the bubbler in place. Then the bubbler riser to the bubbler I DID NOT glue the velocity riser to the bubble riser so you can change direction of flow. I did glue the flow bender to the top of the velocity riser
Statistics
Likes
0
Downloads
0