Creality Ender 3 V3 SE filament runout sensor mount on extruder
Description
I made this mount for the original Creality filament runout sensor, it sits directly over the extruder to minimalize waste material. In theory, if the printer runs out of filament, the printer will auto stop the current print and resume printing only after you refill the printer and confirm to resume print !!! sadly with the current firmware 1.0.6 it isn`t possible to use the filament sensor at all. The connector on the motherboard is a 4 pin but i modified the 3 pin on the included cable to fit on the 3 left pins on female connection at the motherboard. The KE version of this printer has the sensor pluged in at the same connector! If you connect the sensor and put in some filament to load the light turns blue but the printer says [filament about to run out (continue) (stop)] Pressing continue doesn´t do anything and pressing stop cancels the current task. I`ve tried to change the pins red and yellow on the sensor cable an it doesn`t change a thing.!!! Mounting Hardware needed: 3x M3 threaded inserts 3x M3x14 original counter sunk screws (4x includet in the sensor kit) (https://www.amazon.de/Creality-Filament-Sensor-3D-Druckerteile-Detection/dp/B0951X2VBS) 2x M3 x 16 socket head screws to replace the original cable management holder
Statistics
Likes
0
Downloads
0