3.5" HDD trayless hotswap bay
Description
This Is An Untested Prototype: Inspect Fit Clearances Before Printing. This Is A 3D Printed Harddrive Bay For Standard 3.5In Harddrives. It Uses Bare Drives Without The Need For Trays/Rails. The Door Actuates A Lever Arm To Unseat The Drive For Removal. It Fits In A Cd Drive Bay And Mounts The Same Way. Sata Hotswap Capability Requires A Motherboard With Ahci. Required Hardware (Lengths Are Not Strict. Check Files For Exact Hole Lengths): 7 M2X15 2 M2X10~12 1 M3X35 Cd Drive Mounting Screws (M3) Future Plans: If I Can Get Dimensions For A Cheap Sata 22-Pin Cable (Like This One Ebay.Com/Itm/Male-To-Female-7-15-Pin-Serial-Ata-Sata-Data-Power-Combo-Extension-Cable-Fo-/291369269696) I Would Integrate It Into The Rear Plate. This Would Make The Connectors Slide Together More Reliably And With Less Tweaking Of The Dimensions.
Statistics
Likes
38
Downloads
0