Robotic Eyes - independently controller
Description
I designed this to all snap together easily. each eye and eye lid uses its own servo and is able to be independently controller. GH-S37D Servos snap right into the base. The eyelids and eyeballs have attached servo horns. Screws are not required, but will give you a more dependable setup. I use a Raspberry Pi 4B to control everything, but you could use most any Raspberry pi or Arduino. I have only printed this using PLA+, but most filament types would likely work. I do not have any good footage of how to put this together, but it is really simple and all snaps together. See my tiktok for actual footage of the unit assembled until I am able to get more instructions available. https://www.tiktok.com/@3dprintingrobotics?is_from_webapp=1&sender_device=pc
Statistics
Likes
0
Downloads
0