Ego 21" Snowblower Skids SNT2110/SNT2112/SNT2114
Description
# Overview These skids allow an Ego 21" snowblower to work on gravel & other non-cement surfaces. They lift the scraper bar about an inch off the surface. The wide skids work better when the ground is not frozen and/or the snow is light & fluffy. They use the same bolts & bolt pattern, so they can easily be swapped out. <br /> Supports are not necessary. The wide skids have an integrated support. Both sets need to be reamed out with a 5mm drill bit prior to installation. <br /> ## Instructions Clamp the skid to the side of the snowblower, lining the ledge on the skid up with the bottom of the snowblower side Using the skid as a drill guide, drill a 5mm hole through the snowblower side housing Insert M5 bolt from inside of the snowblower housing and screw on nut Adjust clamp and repeat process for the second bolt <br /> ## Tools Required Drill 5mm drill bit Clamp (optional) Deep 8mm socket (for wide skids only) <br /> ## Parts Needed 4 - M5 x 25mm 4 - M5 lock nuts or 8 - M5 nuts (using four as jam nuts) <br/> <br/>
Statistics
Likes
0
Downloads
0