Creality Falcon 2 Emergency Stop Button Shroud
Description
I was sick of accidentally shutting my laser off with my elbow so I made this simple shroud for the emergency stop button on my Creality Falcon 2. Fits my 22w version, I'm sure it fits the others as well. The thru-hole is 16mm and the big red button is ~25mm outside diameter and sits in the closed (up) position at 25mm tall. It could probably be a little taller if you want more protection, the button is a little more sensitive than I thought. As-is, it sits dead flush with the top of the button in the up position with the silver trim ring removed. Just stretch it a few mm taller in Cura of that's what you're looking for. Adapted from an @A3DPrintingFarm model I found on Printables: https://www.printables.com/model/319314-e-stop-shroud Printed with PLA+ in OSHA-compliant yellow. No supports. 20% infill. Took around 45 minutes.
Statistics
Likes
0
Downloads
0