Extruder Exhaust Fan for Overlord Pro
Description
This Fan Enclosure Really Works Well. After Several Hours - The Exruder Motor Is At Room Temp Still. Now I Can Print Pla - Never Could Get Past An Hour Before Because Of The Heat From The Stepper Softening The Pla Causing The Extruding To Stop. Fits A 50Mm Fan X 10 Or 15Mm Thick. Run It As An Exhaust Fan - Pulling Air Over The Stepper And Out The Top. There Is A Fan Connection On The Motherboard That Works For This As Well - Get A 24Vdc Fan! I Am Excited - I Can Print Pla Now! If Anyone Knows How To Reduce The Fan Speed For This Fan Port - Please Post It Up? I Plan To Find Automotive Paint That Matches My Olp And Make It Look Factory. I Hope This Helps Someone Else Too!
Statistics
Likes
20
Downloads
0