TQi Transmitter Remote Battery Cover
Description
I adjusted everything I so hopefully you only have to print once, remove support material and slide on to your transmitter. No resizing needed. I did NOT have to force anything. Its a snug fit but I was able to remove and install repeatedly without fail. Just make sure the support material is completely removed from the tabs. Took about 3.5 hours to print with my settings. You have a choice if you want a logo or not. Suggestions/Feedback are welcomed. Settings Used: Layer Height .16mm Infill 100% Temp 200 Filament PLA Filament Brand SUNLU Color Used BLUE Print Speed 80mm/s Bed Temp 40C
Statistics
Likes
0
Downloads
0