Brace Brackets for Alesis Nitro Frame - ISO Metric M5 Screws Version
Description
This is a remix of [https://www.thingiverse.com/thing:6418186].(https://www.thingiverse.com/thing:6418186) I'm grateful to [ock10](https://www.thingiverse.com/ock10/designs) for his project, however I needed to modify it to match the ISO metric standards and for use with the hex wrench provided by Alesis in the Nitro kit (diameter 4mm). The screws used are 1 M5x40 and 1 M5x30 for each bracket, 2 washers (diameter 11mm) for a better distribution of the pressure on the bracket's surface under the screw's heads. The nuts and the washers fit in with a little finger pressure (or by tightening up the screws) since the holes are only 0.1mm wider than them.
Statistics
Likes
0
Downloads
1