PS5 Dualsense Sim Racing Wheel
Description
I didn't want to spend a fortune on a sim racing setup after already spending a fortune on the VR setup so i came up with this. YOU ONLY NEED TO PRINT 5 FILES. the rest are there in case you need a different file type. the steering wheel needs to be printed with supports. So does the star shaft. and so does the shelf for raiser. the controller fits very snug against the back of the steering wheel so it is a tight squeeze fitting it in there. It need to be tight against the back of the controller to work super well. It fits flush against the back of the controller and the triggers are sticking out of the back for a comfortable grip and to be able to accelerate and decelerate with them. the star shaft fits into the back of the controller. I just used a little hot glue to fix it there.The other end of the star shaft fits on to the bearing shaft. There needs to be no glue there so it can be taken off for storage when done using the sim racing wheel. Print the bearing shaft with good tolerances. Change your horizontal expansion. I did -1 although -.5 might have been a little better. The bearing shaft needs to be glued at the corners to fix it to the base. I have included a raiser and a shelf as i noticed it works better at that angle. The shelf is to give you a chance to add weight to it in case you dont have something convenient like sand while printing the base. Soon enough I will add screw clamps so it can be clamped to a table. infill needs to bed high on the bearing and the shaft like 30-35 percent or more. infill can be just about whatever you like on the baser and wheel. i printed the clip in TPU so that it was more durable.
Statistics
Likes
0
Downloads
0