10 Minute Mini Calibration Test V2
Description
<h4>What is it?</h4> This is a very compact test and calibration model for printing and supposed to supersede my previous model https://www.thingiverse.com/thing:1815784, while keeping the core idea of a 10-minute test. It's goal is to make a test print for various design elements. <h4>What is the reason in it?</h4> * Main goal was to make a calibration test as tiny and effective as possible * Save as much material as possible * Save as much printing time as possible * Show useful test results for retraction and printing quality * Only include the most important and basic tests for proper calibration (in my opinion) <h4>Why this and not others?</h4> There are plenty of other test models out there, either with a very big range of tests, or just one test. Usually they are using a lot of printing material and printing time. However I just wanted to make a quick check, if printing results are okay. Compared to my predecessor, which was really useful over the years, I felt that within 10 minutes more could be tested. <h4>What is in it?</h4> * Fast: Print in less than 10 minutes (depends of course on printer speed) * Small and lightweight: 1.3g at 40x13x12mm * 3D printer friendly: No supports, rafts, brims, ... * Bridging at ~ 16mm: Top bridge with 1 layer only (0.2mm) and bottom bridge with 3 layers (0.6mm) * Stringing and oozing check between left and right tower * Overhangs at 40°, 50°, 60°, 70° * Slots/gaps at 0.1mm, 0.2mm, 0.4mm, 0.6mm, 0.8mm, 1.0mm * Fillet 2mm and 6mm in layer direction * Chamfer 45° in layer direction * Letters with 4mm height * Tapered tip 45° * Inner edge 90° * Space for label sticker on bottom side (12x24mm)
Statistics
Likes
0
Downloads
0