Tesla J1772 Adapter Trunk Holder 2023 Model Y
Description
This design uses the charger emergency release compartment of the Model Y as a place to mount the holder. This design allows quick install and removal process without any use of tools or hair dryer. Installation Instructions: Insert the top triangle section into the Triangle cut out (Charger Emergency Release) on the left side. Turn/twist the holder to have the flat surface face out and the holder should snug in place and won't fall out. Removal Instructions: Turn/twist the holder to align the cut out triangle hole with the holder. Slowly tilt and slide the holder out. Recommendation : 1. Use support for the small triangle. 2. Print in PETG if possible especially in regions with high temperature. 3. Apply small tape to the top of the lager triangle to prevent plastic to plastic contact and possible scratches. I used FlexTape but Electrical tape should work (refer to third image) 4. Attached a second file with lager gap between the two triangles.
Statistics
Likes
0
Downloads
0