SXC10 IFS conversion
Description
This is a custom high clearance system to convert an SCX10 to a trophy truck. Got the idea from the proline twin _beams. But can justify the 100$ and figured I could do it a different way. This is measured out to use traxxas suspension. I have included modified high clearance A-arms that also match the the width of sxc10 and 10ii rear axles. you can use any of the traxxas A arms and casters. This is the full setup including rods and rod ends to get 8 degrees of camber for cornering. I recommend putting a support between the shock towers and printing in ABS. Can be printed as is or for best results it will split into each part with mesh tools. I print the A arms vertically on the short side for better strength, you can also lay them flat, but with PLA they will likely break. Use all the traxxas stock hardware for rustler 2wd front end. For the steering link, an aluminum servo horn and custom length rods. stack the rods on the horn and to the caster blocks. the upper links and rods from the front of the scx10 should be the correct length. since you wont need those anymore. let me know what you think should change. I recommend using rear trailing arms from an axial bomber or wraith and moving the center skid back, adding a forward battery tray.
Statistics
Likes
0
Downloads
0