Skinny TUSH++
Description
- The original 3mm walls of the TUSH (The Ultimate Spool Holder) were way too thick to fit inside of the [generic cereal boxes](https://www.amazon.com/dp/B08TWH2QHV) I had while using a 68mm wide Bambu spool. - The walls in this remix are 1.4mm, with added reinforcement along the bottom to keep it strong despite the thin walls. - It's compatible with [TUSH++ rails](https://www.thingiverse.com/thing:2451368). Since the walls are thinner, it wobbles a little bit on the rails. If this is a problem, the wedges can be used for extra support. # Instructions - All items can be printed without supports. - I used a 0.4mm nozzle with 0.2mm layer height on a Bambu P1S. - Assemble using 4x [608 ball bearings](https://www.amazon.com/uxcell-Groove-Bearing-Double-Bearings/dp/B07FF1RBPV) that snap into the pegs. - The .f3d file is included if you need to change the thickness or if the bearing pegs need to be modified for your printer.
Statistics
Likes
0
Downloads
3