Automatic power off for Ender3
Description
Holder for microswitch with roller, for automatic power off of Ender3 I decided to design this thing to automatically turn off the printer after printing is finished. While the hot table is in the X-200, the table roller holds the microswitch in the off position. To install it, you will need: -2 screws M4 12mm -2 nuts with hammer head M4 -electric cable 20 cm -MSW-13, Microswitch with ROLLER 17mm ON-(ON) (5A 125/250VAC) SPDT 3P Installation: -Solder the cable to pins 1 and 3 of the microswitch network cable -Pass the cable through the hole in the holder to the other side. --Push the microswitch into the holder all the way into the housing. --Remove the X direction tension roller -Install a pair of TNut in the right groove of the aluminum profile --Return the roller to its place. --Insert this wire into the printer's power gap, and securely isolate the connection point.
Statistics
Likes
0
Downloads
1