Table Leg Extender
Description
Im all new to this, so let me know if any information is missing. My problem wich ended with this project: I bought an old tabel and some old chairs, but the chairs couldet go under the table. I designed a circel in TinkerCad with a diameter on 58mm wide and 15mm in height. On top og that i made a circle with a hole in the same diameter of 58mm and set the wall for 1 which made it 3mm wide, so it wont brake off, so the hole is 55mm wide. I made the wall 10mm high, so the extender works like a cork and you dont need any screws. You can modify the model for fitting your table leg. Measure the diameter and fit the model to it. I attached a file from TinkerCad and the file from Cura. Guess Cura saves the settings from my printet setup. Hope anyone can use this.
Statistics
Likes
0
Downloads
1