Webcam cable guide for Artillery SideWinder X2
Description
I attached my webcam on top of my printer (see my [webcam mount for Artillery SideWinder X2](https://www.thingiverse.com/thing:5570805) design). Thus I had its cable hanging and putting at risk my prints. So I design those two little guides to make sure that the webcam cable stays out of the Z-axis and the printing bed. ### BOM *Top mount:* - M5 washers x4 - M5 12mm x2 *Z-axis mount:* - M3 T-Slot nut x1 - M3 8mm screw x1 ### Mouting instruction *Z-axis mount:* - Simply screw the guide with the T-Slot nut *Top mount:* - Unscrew the two M5 screws - Put washers in the plastic support holes. Two per hole (where the screw heads was laying). - Screw the guide with the replacement screws (M5 12mm)
Statistics
Likes
0
Downloads
0