Meiho 7070 Jarabait holder
Description
I printed this item in 2 pieces all at the same time and glued them together. I specifically designed this so that it can be printed without the need for supports other than on the joining block in the middle please see screenshots. If you have a bigger printer it would be possible to print this as one piece. This is sized for the Meiho VS 7070 box. I would be very grateful for a donation as it did take some considerable time to learn how to design these items and get them all printed and ready to share paypal.me/GarethDParry Material: PLA+ or PETG recommended Infill: 25% Supports: Not everywhere. Extra materials required: 4 x M5 x 50 Bolts 4 x M5 nuts 8 x M5 washers 5mm Drill bit to attach the holder to the Meiho box, it is possible to attach 2 of these holders one above the other onto the side of the Meiho box, or 2 Karabait holders or once of each, please see the attached photos.
Statistics
Likes
0
Downloads
0