Creality K1 bowden tube side mount filament guide
Description
Hey! 🙂 There is a bowden tube filament guide arm for the Creality K1. It can be mount on the place of the 2 existing screws. Unfortunately they are too short, so you can't reuse it. You will need a new 2 longer screws (M2.5 - 1.5 mm length). It can be mount at any directions at any side of the printer. (Keep in mind that for the some of positions you will need to extend the bowden tube) There are 2 versions: 1. short, so you can bypass the filament sensor 2. long, with the pad for the filament sensor (you can place it on any side of the pad) You will need to extend it wire harness tho. You can do it with the 20-30 cm set of the JST XH 2.54 3-pin connectors, thats wildly available on the Amazon and Aliexpress. Print with supports in the position as shown on the photo. I found it's best to print with TPU 95A - it stiff enough but at the same time it can travel back and forth to adjust it's position and guide the filament better. To screw the bracket and the filament sensor you can reuse their own screws. It's a self tapping screws, so you will need to apply some force when you screwing it for the first time.
Statistics
Likes
0
Downloads
0