Syntakt / Digitakt / Digitone Angled Stand
Description
I wasn't sure what angle i wanted my *takt's at, so i designed them at three different angles - 10, 20, and 30. 10 is nice, 20 is great, and 30 is great too, but depends on how much clearance the cables have in the back. These use the VESA mounts on the underside, i'm using 10mm thumb screws on mine. At the mount holes the stand is 5mm thick, and elektron says that you should keep the screws depth inside the machine to under 7mm. So if your using a 10mm screw, then only 5mm will go into the mount, which is good. ensure your screw length is ok, i take no responsibility. i dont have pictures, but these have all been printed and tested for fitment - all good to go and require no modification to machines.
Statistics
Likes
0
Downloads
0