VW Eurovan Dash Speaker Adapter
Description
This is an adapter that enables you to replace the factory dash tweeter with a 3.5" coaxial speaker. The adapter snaps snugly into the same opening designed for the tweeter. It is designed to accommodate the mounting ears of a Harmony HA-R35 speaker. You'll need to trim the end of the speaker ears to accommodate the overall dash opening. After that, put a dab of epoxy, gorilla glue, or whatever to attach the speaker to the adapter, and then snap the adapter into the opening. The adapter will also snap out of the dash opening, but requires some minor force or prying. The adapter also has a small protruding "key" in the mounting bezel that lines up with a notch in dash mounting hole that will ensure the speaker and adapter cannot rotate in the circular mounting hole. The key is oriented so that the harmony speaker connectors below the dash are in the same region as the original tweeter mounting points. The stl file is for the right hand speaker. To print a left-hand speaker where the key will cause the left-hand speaker connectors to end-up in the same place as the OEM tweeter, flip/mirror the stl in your slicer along the vertical axis before printing. I don't think the orientation of the key and connectors is critical for the OEM wiring harness to reach the connectors, but you have the option of printing a left-hand version of the adapter if that matters to you.
Statistics
Likes
0
Downloads
0