200mm "YardCopter"
Description
Mini Acrobatic / Racing Non-Fpv Quadcopter This Is My Latest Design Straight Out Of Sketchup! :D Totally Printable Sans Wooden Booms And Electronics, I Designed This Quad To Be A Replacement For All The Nano-Qx Type Things I Had Burnt Out Over The (Would Say Years, More Like Weeks). Specs - Flight Controller Mounting Point Spacing: 30.5Mm (Kkmini, Cc3D) Booms: 10Mm X 10Mm, X2 95Mm, X1 200Mm Whats Printable: - Top And Bottom Plates Triangular Motor Mount Required Hardware: - X8 M3 Bolts For Motor Mounts, And Mounting Flight Controller X12 Bolts (And Nuts If Necsessary) To Mount Motors (Whatever Size Works For You, Holes Are Undershot) Required Electronics: - X4 Motors (15Mm Triangular Spacing) X4 Escs Receiver, Flight Controller, Etc. Battery: - Well Under Or Up To 1300Mah, Or 90 Some Grams Seemed Good At The Time. Note: No Battery Strap Slots Yet, Thats In Rev. 2 :)
Statistics
Likes
9
Downloads
0