Type A Machines Series 1 Filament Guard Clip
Description
This Straw Keeps The Filament From Dragging On Support Bar For A Type A Machines Series 1. Http://Www.Typeamachines.Com/Products/Series-1-3D-Printer-The-Future-Of-3D-Printing I Have Not Tested Tested On The Pro (Let Me Know If It Works?) Supplies Required: 2 Large Starbucks Straws 1 Left Clip 1 Right Clip Print Clips Vertically So The Nub Is Standing Up. Cut One End Of One Straw Vertically For About 2 Inches. Collapse The Straw Tube And Roll It Inside The End Of The Other Straw, Insert As Far As Possible. The Clips Go On Snug. Feed The Straw Into The Clips, Cutting Where Needed. It'S Best To Leave The Seam Of The Straw Far To One Side. If You Printed Vertically, And The Nubs Come Out "Melted" Or The Surface Is More Shiny Than The Lower Parts, Increase Your Minimal Layer Time (This Print It Was 16 Seconds), Or Your Temperature Is Too Hot Overall. Source Files: Https://Github.Com/Esromneb/Massive-Octo-3D-Print-Adventure/Tree/Master/Typea_Bar
Statistics
Likes
3
Downloads
0