Speakeasy Arms 2A Calibration Cube
Description
**Read the Instructions!** **Print in provided orientation, on its corner!** This is a new type of Calibration Cube - Designed to test Bed adhesion, Overhangs, Dimensional Accuracy in <u>ALL</u> directions, E,X,Y,Z steps, Small Details, and more! This was deigned with 2A in mind - If you can print this at the recommended settings successfully, you can print anything <b>2A</b> related <i>without<i/> supports. <b><u><i>This is designed to be printed with NO supports an NO bed adhesion. If you're not worried about the adhesion because you print with a brim anyway, that's fine and a brim is okay, but is a failure of the test technically. Supports can NOT be used to successfully pass this test. Brim or Raft cannot be used either to successfully pass this test. If you have a option for bridge cooling, these settings are allowed and encouraged. PRINT IN PROVIDED ORIENTATION ON ITS CORNER! 2A people: Print this using the same settings and material you would print your 2A stuff with, but with Supports and adhesion turned off. Skirt is the only :Adhesion" allowed. Fuzzy Skin will throw off dimensions so no fuzzy skin. General users: Print this with no supports and no brim or raft. 100% infill. 2 walls. 6 top, 6 bottom layers. Fuzzy skin will throw off dimensions so no fuzzy skin.</i></u></b>
Statistics
Likes
0
Downloads
0