genmitsu 3018 pro 52mm dust shoe adapter
Description
Dust shoe adapter for the standard 42mm spindle on the genmitsu 3018-pro cnc to a 52mm spindle. Will likely work for other machines, just double-check clearances. --- Additional parts required: - 1x: m6 x 30mm cap head screw - 1x: m6 square nut (10mm) - 2x: m4 x 7.5mm cap head screw - 13x: 5x3 small round magnets --- Assembly: - Make sure the magnet recesses for both the 42mm base plate and the 52mm adapter are clean and cleared of any excess filament. - Take 7 magnets and mark one side of each of them so the polarities all face the same direction. - This lets you rotate the adapter in case of clearance issues or for the sake of convenience. - Take the remaining 6 magnets and mark the opposite polarity as before so when pressed marked-side down into each part, the magnets attach. - NOTE: Glue may be used but is not necessary as the magnets are a fairly tight fit. - NOTE: Pressing the magnets will likely require a pair of pliers or heavy, flush object - depending on print settings, most (if any) won't be able to be pressed in with just your hands. 42mm base plate: - Press each magnet into a 5mm recess (there are 2 slightly smaller 4mm holes for the mounting screws) until it is flush with the base plate surface. - Mount the plate magnet-side up to the dust cover top (see image for reference) using the 2 m4 screws. 52mm adapter: - Press each magnet into a recess until it is flush with the adapter surface. - Slide the m6 screw through the clamping hole (may need to drill it out depending on print settings - if so, do so carefully as the sides can crack) and thread it into the m6 square nut.
Statistics
Likes
0
Downloads
1